Keep it simple... keep it going... and keep it!
  Home> Operation> Hydraulic Lift

Page 2
Page 3
Page 4
Page 5
Page 6
Page 7
Page 8

Search for Manuals
at Simplicity's Technical Publications Site

Enter the MFR Number:

Shirts, hats, mugs & more in the

You can make a contribution to support Simple trACtors online, safely and securely, using our PayPal account.



The following instructions are prepared as an aid in mounting the Hydraulic System on the B-10 and Big Ten Tractors. Follow the sequence of steps as given. After completion of hydraulic system mounting, be sure system is filled with the proper oil before operating.  

Click for a closer view
figure1.jpg (41885 bytes)
Figure 1

1.  Remove tractor hood and battery.

2. Remove lift lever and quadrant assembly from lift shaft assembly. Note that two capscrews that attach the quadrant assembly also hold the lift shaft bearing and must be replaced after quadrant removal.

3. Remove L. H. and R. H. side panels.

4. Remove attaching screws from dash assembly. Be careful not to overlook attaching nut on the back side of dash assembly.

5. Remove attaching screws from frame cover being sure to remove screw from shift rod guide.

6. Lift dash assembly up as shown in Fig. 2 and remove frame cover.

Click for a closer view
figure2.jpg (33134 bytes)
Figure 2

[Source:  Allis-Chalmers publication,  Form No. TM-431, included in B-12 Owners Manual courtesy of Mark Waite & Joel Wicker]




NOTE: This site is designed to be viewed in at least 1024 x 768 resolution in Internet Explorer v6 or later, Mozilla Firefox v4 or later, and Google Chrome.  It may not display correctly in other resolutions or on other devices.  Links on this site are monetized.  We assume NO liability or responsibility for the accuracy of ANY data on this site.    
1998 - 2011 by Simple trACtors LLC, North Brookfield, MA. All rights reserved.


Please support our sponsors  . . . 
and help keep this site free for your use.